How to replace Plastic Oil Filter Covers?- Taizhou Kelong Plastic Mould Co., Ltd.

Step 1: Vehicle preparation. Run the engine to operating temperature. Then jack up the vehicle with a jack, pull up the handbrake and squeeze the front wheels with a wooden wedge. Drill into the chassis to see the situation (please be sure to know the special safety precautions mentioned in your user manual first).

The second step is to drain the old oil. Use a 15mm wrench to loosen a little oil plug screw counterclockwise. Don't screw it too much. At this time, put the basin with the plastic bag under the screw (put it back slightly to prevent the oil from spraying far away when the oil just comes out.) After placing the basin, continue to screw the screw by hand. When the oil drips bit by bit, carefully screw out the screw. Do not burn with hot oil. (Maintenance is recommended when the car is cold.)

Step 3: Remove the China Plastic Oil Filter Covers Manufacturers. When the oil flow is almost complete, use the filter wrench to remove the filter, open the oil cover on the engine cover, and use the filter wrench to unscrew the oil filter element counterclockwise. Screw out the oil filter element from the engine compartment and be careful not to touch the hot exhaust manifold. At this time, there is still a little residual oil in the mechanical filter. Be careful not to drip everywhere.

Step 4: Preparation before installation of oil filter element

There are two ways to install the engine oil filter element. The common way is to install the filter element vertically. Many small digging machine filters are installed horizontally. The installation methods are different, so there are two cases of oil filling:

1. First of all, the vertically installed oil filter element is connected to the oil pump through an oil pipe. In this installation mode, it is generally recommended that users replace the filter element and fill it with oil. If the new Plastic Auto Engine Water Pipes Factory is not filled with oil, air resistance will be generated inside the new filter element, which will cause the lack of oil lubrication in the machine for a short time when the vehicle is parked, and will cause the wear of structural parts. The advantage of vertical installation is that the filter element has better sealing performance, and oil leakage rarely occurs.

Before replacing the machine filter, first find a clean environment, remove the protective film, and then fill the new machine filter with engine oil. Pay attention to the surrounding environment during the oil filling process, check the oil barrel and the oil filling port to ensure that no dirt and other impurities are brought in. After the engine oil is filled, use your hand to put the engine oil on the sealing ring to increase the sealing performance.

2. Besides, the oil filter element installed horizontally is directly connected to the oil pump without passing through the oil delivery pipe. This design does not create air resistance inside the oil filter when filling the oil tank. The filter element does not need to fill the oil in advance before installation. The oil filter element can be directly filled with oil while filling the oil tank with new oil.

TESLA Water Pipe 1077589-00-D

✔️ OE Part Number: OE# 1077589-00-D

✔️ Easy installation - This Water Pipe is a direct replacement, easy installation and high sealing, perfect match for the original car and work like the original part.

✔️ Quality Assurance - This Water Pipe is made of premium plastic, not easy to deform and durable in use. One year warranty.